How long does a furnace last?
Fifteen to twenty years is the range usually quoted for a gas furnace, and well-maintained units in a mild climate frequently exceed it. Sacramento’s short heating season means furnaces here often see fewer run hours than the national average, which works in your favour.
Age alone is not a reason to replace anything. Age plus a repair quote, or age plus a safety concern, is.
What actually determines furnace lifespan
Run hours, not calendar years. A furnace in Sacramento works far fewer hours a year than one in Minnesota. Two identical units of the same age can be at very different points in their lives.
Installation quality. A furnace that was correctly sized, properly vented and connected to adequate ductwork lasts longer than one that was not. Oversized furnaces short-cycle, and short-cycling is hard on the heat exchanger.
Filter discipline. The cheapest thing on this list and the one most connected to lifespan. A restricted filter makes the unit run hotter and work harder.
Ductwork. Undersized returns starve a furnace of airflow, which raises operating temperature and stresses the heat exchanger.
Whether it has been maintained. The basic annual check is what catches a cracked heat exchanger or a failing inducer before it becomes an emergency.
What are signs of a dying furnace?
Safety signals — act on these immediately, regardless of age:
- A yellow rather than blue burner flame
- Soot around the unit
- A persistent smell of gas
- Any carbon monoxide alarm activation
- Visible cracking or corrosion on the heat exchanger
A cracked heat exchanger is not a repair decision. It is a replacement decision, and until it is dealt with the system should not run.
Performance and cost signals:
- Rooms that no longer reach setpoint
- Cycling on and off more frequently than it used to
- New noises — banging on ignition, rattling, a persistent hum
- Heating costs rising while usage has not
- More than one repair in two seasons
How do you know when your furnace needs to be replaced?
One rule of thumb that circulates widely: age multiplied by the cost of the proposed repair, with $5,000 as the rough threshold above which the rule points to replacement.
Then override the arithmetic in three situations:
- Any heat exchanger fault. Replace, regardless of what the numbers say.
- Parts are no longer available. Common on units past twenty.
- The furnace and AC are both near end of life. Replacing both together costs less than two separate projects and gets you a properly matched system.
Should a 25 year old furnace be replaced?
Yes, in almost every case — and preferably before it fails rather than after.
At twenty-five years a furnace is well beyond its expected service life, its efficiency is far behind current equipment, parts are becoming difficult, and the heat exchanger is at an age where cracking becomes a genuine risk rather than a theoretical one.
The one thing worth doing first is a safety inspection, because it may change the timeline from “plan this year” to “do this now.”
Can a furnace last 30 years?
Some do. A well-made unit, lightly used in a mild climate, correctly sized and maintained, can reach thirty.
Whether it should still be running is a different question. A thirty-year-old furnace is substantially less efficient than current equipment, has a heat exchanger well past the point where inspection is optional, and will fail eventually — probably on the coldest night, which is when replacement costs the most and the choice is narrowest.
If you have one still running: get it inspected annually without fail, and plan the replacement rather than waiting to be forced into it.
What is the average cost of a new furnace?
A national average for a furnace is close to meaningless. What moves the total, roughly in order:
- Ductwork condition. Sealing, repairing or replacing ducts is frequently the largest single variable, and it is the one most often left out of a cheap quote
- Equipment tier. Single-stage, two-stage and fully modulating equipment sit at genuinely different price points
- Capacity, set by a load calculation rather than by what is there now
- Electrical work. A panel at capacity turns a straightforward job into two trades
- Access. Attic and crawlspace conditions change labor hours before anything else does
- Venting and condensate routing on furnace work, and line-set runs on heat pump and ductless work
Why furnace quotes differ
Capacity, ductwork condition, venting changes, condensate routing and equipment tier all move the number, and they move it further than the age or size of the house does. A lower quote frequently describes a narrower scope rather than a better price. More on why quotes vary →
Replacing the furnace and the AC together
Worth considering if both are past twelve to fifteen years. One project rather than two, matched equipment that performs as designed, a single permit and inspection, and — in this climate — an opportunity to ask whether a heat pump makes more sense than replacing a furnace and an air conditioner separately.
Cobex Air installs and replaces heating and cooling systems in Fair Oaks, Sacramento and the surrounding area. Licensed C-20 and C-10 (CSLB 947360), BBB Accredited A+, and a contractor in SMUD’s Contractor Network — which is a condition of SMUD’s heat pump rebates. See our HVAC replacement service.
Frequently asked questions
What is the average cost of a new furnace?
An average is misleading here, because capacity, ductwork condition, venting changes, equipment tier and any electrical work move the total more than the house does. The spread usually traces to the capacity each quote is sized for, whether ductwork is in scope, the equipment tier and what has been excluded.
What are signs of a dying furnace?
Safety signals first: a yellow burner flame, soot, a gas smell, any carbon monoxide alarm, or visible heat exchanger cracking — all of which mean stop and get it inspected. Performance signals include rooms not reaching setpoint, more frequent cycling, new noises, rising costs and repeated repairs.
How do you know when your furnace needs to be replaced?
A widely used rule of thumb multiplies age by the proposed repair cost, with roughly $5,000 as the threshold that points to replacement. Three situations override any arithmetic: a heat exchanger fault, parts no longer available, or a furnace and air conditioner both near end of life.
Should a 25 year old furnace be replaced?
In almost every case yes, and ideally before it fails. At that age efficiency is well behind current equipment, parts are getting difficult, and heat exchanger cracking is a real risk. A safety inspection will tell you whether the timeline is this year or immediately.


